Chevrolet BLAZER EV Safety Recalls

The onstar module failed. Also controlling the pedestrian px Proximity sensor and crosstraffic sensor. When driving slowly waiting a parking lot the vehicle locked up on the brakes with the warning message pedestrian alert. The area was clear. No pedestrians were in the vicinity This would be the 3rd incident 1st was cross traffic already braking while entering a light only at a speed of 15 mph. 2nd was the cross traffic and 3rd was the pedestrian alert.. We discovered the onstar module contrs all of these functions. Contacting the dealer theu stated the module need to be replaced but there is not an ETA on the part arrival as this is a common issue with all vehicles that contain. This module. We are scared it will happen if a driver pulls in front when in traffic or put us in a precarious even deadly situation

1. Vehicle has a horrible squeaking sound coming from the brake pedal area. First dealer diagnosed it as the master cylinder needing replacement. Noise did not go away and GM said that it is normal. The noise is not normal and has never been on any other car I have owned. 2. When reversing, the car sometimes abruptly slams on the brakes as if it is avoiding a collision even though no collision is close to happening. GM refuses to fix the problem.

The contact owns a 2025 Chevrolet Blazer. The contact stated that after the vehicle was repaired under NHTSA Campaign Number: 25V433000 (PARKING BRAKE), while driving approximately 45 MPH, the Forward Collision Avoidance system erroneously activated, causing the vehicle to abruptly stop in the middle of the road. During the failure, the message "Front Brake Applied" was displayed. The contact stated that approximately 10-minutes prior to the failure, the message that the Forward Collision Avoidance sensors were disabled. The cause of the failure was not yet determined. The local dealer was notified of the failure. The manufacturer was not contacted. The failure mileage was 18,000.

At a low speed, between 10 and 15 mph, the forward collision system automatically triggered and brought the car to an immediate stop. While we were lucky that no car was following behind us, the passenger and I experienced significant whiplash and lasting back pain as a result of this. The vehicle has not been inspected by anyone, and not been reproduced. The forward collision system flashed (red warning light, alert).

Multiple safety-critical malfunctions have occurred on this vehicle involving unintended braking, unintended acceleration, and false activation of driver-assist systems. These events did not happen at the same time and occurred under normal driving conditions. At various points, the vehicle has suddenly applied the brakes without driver input, including hard braking events that felt like an automatic emergency braking activation when no hazard was present. In separate incidents, the parking brake has engaged while the vehicle was in motion, causing abrupt deceleration. There have also been instances of unintended acceleration where the vehicle surged forward briefly without additional throttle input. These malfunctions appear to be related to electrical or ADAS system faults affecting braking logic and propulsion control. No warning lamps or messages reliably appeared before these events. The issues pose a serious risk to the safety of the driver and others because the vehicle’s behavior is unpredictable and can interfere with safe control. The dealership was unable to reproduce the conditions during inspection, but the incidents have occurred multiple times in real-world use.

There is a really bad rattling noise that comes from the dash. The dash at the windshield you can push down very easily. Whem driving on rough road the ratteling noise is very loud and distracting. During daylight driving you get a very bad glare from the dash board in the windsheild. I havent found a dash mat yet to fox the problem temporarily but some people have mentioned trying felt.

My windshield is defected with no real time when a replacement can be ordered..the interior lining is not sealed properly which is causing a buckling effect by drivers and passengers visors.. Rain is getting inside and soaking into the dashboard causing the electrical system on screens to blink in and out Finally my brake harness is still on recall and my car has been shifting into park which could cause severe problems if I am on the highway..

This is a report of defective software that could increase the chances of an accident, injury and or death. This vehicle features a built-in garage door remote which is utilized exclusively through the touch screen. However, when the vehicle is in reverse the backup cameras restrict access to the needed menu. After backing up and putting the car in drive there is a delay before the back up camera turns off. This creates a situation in which the driver must wait in the middle of the road after placing the car in drive before being able to close the garage door. In seeking solutions from online forums, some drivers have reported their Blazer EVs allow the button to be accessed while others report they do not, so I speculated perhaps I missed a software update, but per the car's OTA system, the vehicle's software is current as of the time of this submission. I have recorded a video that I am happy to share , however it exceeds the size limit allowed for uploads in this report.

At certain times of day it is nearly impossible to see through the windshield as the glare from the dashboard reflection is very bright. The attached pictures do not really show the extent of the glare.

The contact owns a 2025 Chevrolet Blazer. The contact received notification of NHTSA Campaign Number: 25V433000 (Parking Brake); however, the part to do the recall repair was unavailable. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The dealer was contacted and diagnosed that the windshield was not installed properly and needed to be replaced. The contact stated that while raining, water leaked into the vehicle through the windshield onto the dashboard. The contact stated that the seal had detached on the passenger’s and driver’s sides of the vehicle. The contact stated that while driving at an undisclosed speed, the vehicle shifted into park(P). The vehicle had to be turned off and restarted to shift out of park(P). The failure had occurred while driving, idling, and while parked. There were no warning lights illuminated. The dealer also discovered that the hood of the vehicle and the windshield were not flush, causing a slight detachment. The vehicle was not repaired. The manufacturer was made aware of the failures; however, no assistance was provided. The failure mileage was approximately 3,000.